SP2A/HP3D T-Probe

Elster Part# MEB7454

Open

 

 

• 1 Installation Instructions
• 2 Pulse Rate
  • 2.1 5:3 Dial V100 (3 red rollers)
  • 2.2 4:4 Dial V100 (4 red rollers) - uncommon

Installation Instructions

Step 1. Push the sensor cable up its plastic housing.

Open

 

Step 2. Place the T-probe sensor into the probe hole. Make sure you the screw holes on both the V100 water meter and the T-probe sensor are aligned.

Step 3. Screw in the M3 flathead screw into the hole. Check that the probe is sitting flush on the meter.

Open

Step 4. Pull the sensor cable back just enough to cover the top of the screw.

Pulse Rate

5:3 Dial V100 (3 red rollers)

Pulse Rate = 5L/pulse

Open

4:4 Dial V100 (4 red rollers) - uncommon

Pulse Rate = 0.5 L/pulse

Open