Taoglass External Road-Marker Antenna Install

Drill

10mm Drill bit (steel)

Screwdriver

Heat gun

1

Ensure lid surface is as flat as possible before mounting the road marker antenna.

Use a 10mm drill bit to drill a hole on the lid of the pit.

2

Feed cable through top of lid, where the antenna should neatly mount on the exterior as shown in the image.

3

Take your Taggle Device and install sensor on meter.

*Refer to Taggle installation Guide.

4

Slide resin-filled heat shrink over antenna cable coming out of Taggle Device.

5

Connect Device Antenna cable to road marker antenna cable.

6

Swipe Test.

Make sure the tag is appearing in the swipe page with the pit lid closed.

*Refer Swipe Tool Guide

7

Use heavy duty adhesive to mount antenna to pit lid.

8

Center the heat-shrink on the antenna connection and use a heat gun to activate the heat-shrink.

10

Mount the Taggle Device as high as possible in pit using appropriate saddle clamp.

Use cable ties to neaten cable, being sure to leave enough slack in the cable so it’s longer than the pit tether in the next step.

11

If no tether exists on pit lid, use a wire rope to tether lid.

The tether must be shorter than the antenna cable.